INSTRUCTIONS

WITH
APPLICATION
TAPE

STEP 1: CLEANING

Vinyl stickers adhere best to smooth, clean surfaces rather than textured ones. Wipe the surface in one direction only, using a clean, lint-free towel or fabric.

STEP 2: PLACEMENT AND PREVIEW

If necessary, cut individual parts of your sticker from the sheet and lay them on the floor or table to understand the sequence for applying the sticker to the surface and visualize the final result.

STEP 3: ALIGNMENT

Place the vinyl sticker on a firm and flat surface with the image facing up. Smooth out the transparent application tape carefully using a plastic credit card.

STEP 4: REMOVE THE “RELEASE LINER”

Start from one corner and slowly peel off a portion of the paper backing from the sticker.
Ensure the sticker stays on the transparent tape!

  • Decals with intricate features may resist peeling off the “Release Liner”, in which case, stop, and smooth the sticker on the “Application Tape” again.
  • Be careful and work slowly to avoid damage to your vinyl decal.

STEP 5: APPLICATION TO SURFACE

Using the “Application Tape”, bring the sticker close to the surface you want to adhere it to. Align the sticker as it should be. Slowly and carefully stick one corner of the sticker to the surface, then begin smoothing it with a plastic card over the surface, pushing out air bubbles. Continue sticking and smoothing the sticker onto the surface until the end.

STEP 6: REMOVE THE “APPLICATION TAPE”

Smooth out only the sticker on the wall! This helps the sticker adhere well to the surface. Start from one corner and slowly peel off the “application tape” at a straight angle. If any parts of the sticker remain on the “application tape,” simply stop pulling, roll back slightly, and smooth the sticker onto the surface so that the sticker adheres better to your surface. Then slowly continue removing the “transparent application tape.” If necessary, help the vinyl sticker come off from the “application tape”, then smooth the sticker over the surface.

STEP 7: ???

Great job! If after applying the sticker there are still bubbles, just carefully pierce them with a sharp needle and then smooth them out.